The damage will be caused to green laser pointer

The damage will be caused to green laser pointer.
Before the gas line section cover installed, close the front cover of the machine, and reload the IP board test machine, the machine returned to normal. Note: CR900 mechanical moving parts are mostly driven by compressed air, so there is a very complex part of the gas line, gas line part of the pipeline more prone to the phenomenon of abnormal movement of the mechanical parts of the joints loose leak, so daily use of the process should pay attention to maintenance and upkeep in order to avoid the phenomenon of the gas line leak. The scanned image appears in the white bright line. Fault phenomenon: long axis parallel to the scanned image appears fine white bright line, shadow, white bright line video, and IP board, and biased towards the right, that is, biased towards the front of the machine in the scanning position with the cover side. The laser beam light of green laser pointer should be avoid being irradiated to the eyes.
Different position with different sizes of the IP board, but the basic fixed position in the IP of the same size board. Troubleshooting: First suspected individual IP board, the different sizes of the IP to scan images were compared and found that the remaining size of the IP boards have the same problem in addition to the IP board 8 × 10, However, the extent of the bright lines appear different, some with higher brightness, some brightness is not too high, it is not obvious, and are relatively fixed position of the IP of the same size board bright line appears, after careful analysis to confirm should be in the optical path due to the dust. The superstructure of the machine to lift open the side cover and the left side of the machine. The warning label should be added and attached to green laser pointer .
The lens prism in the optical path carefully with lens paper to wipe clean, bright lines still exist by the test. At this point, the only photoelectric tube in front of the filter plate is not clean, it is likely because of dust on it led to the failure. Then turn the machine on the front cover, IP board to erase lamp removed in the filter plate in front of the IP board population at the phototube to wipe clean, the cover of the machine installation recovery, and erase the board lights to reload the machine, test machine CR900 work as usual, scanning the image piece of bright lines disappear, the machine returned to normal. Why the IP board 8 × 10, there is no bright line on the road, according to our analysis that. It is to remind some note and attention concerning about the use and safety of green laser pointer.This switch is used only as a service technician P208 door fail open the front door can not open. Press and hold the door button for 5 seconds, the camera will be forced to open the door. (In the darkroom) P506 printer error due to processor failure can not print photos. Re-open the machine. P509 printer error due to processor failure can not print photos.